Browse the parts catalogue

Air intake grille. For Defenders equipped with a 300 Tdi, Td5 or Puma motor.

This is the defender door's sill lock button

Defender door card clip

Keep snow, ice, and leaves out of your heater intake with this Snow Cowl. The heater intake cover fits Left Hand Drive Defenders (this goes on the Right Hand Wing).

Land Rover Defender Internal Door Handle

Land Rover Discovery 2 window and heating switch cover. You need to print 4 pins.

Defender wing grills, need drilling.

Plastic bushing fro Land Rover Defender bonnet

This is a defender door's lock escutcheon

Land Rover Defender Door Panel Dowel

Simple light guards for Land Rover Defender, just attache them with the original screws.

This is a defender door's lock button housing

Land Rover Discovery 2 horn button cover.

This is a defender's door card clip mount

A cup holder that clips to the metal dash of a Series 1-2a.

Originally built to mount a Bolt&Trim Leather speaker holder for the Marshall speaker. This allows for a temporary/movable mount based originally on a cup holder. Could be easily modified for other speaker styles.

This is a defender's seat lever knob

Defender Bonnet Stay Clip, requires a 3mm Allen screw.

Land Rover defender mirror hinge bottom cap

Land Rover Discovery 2 bonnet (Hood) prop grommet

Trim Clip for Fuse Box Cover on Defender from 2007 Onwards

Clip to hold brake pipes to chassis for Defender TD5. It fits into existing 7mmØ holes in chassis and holds a 5mmØ brake pipe secured by a 4.7mm*1.3mm nylon cable tie. It's designed to be forced into the chassis with a hammer and strongly hold the brake pipe even without beeing secured by the cable tie, but be aware that brake pipes are quite sensible parts of a vehicle and may result to your death if not secured appropriately. Use this part at your own risk and check conditions of the brake pipe clip regularly.

Adaptor to fit Discovery 2 Cruise Control switch to Defender td5. Quote from SimonRafferty: "It's very easy to add cruise control to any Td5 Land Rover Defender just by adding a couple of wires to the ECU and connecting them to a switch. (search on line for details) Unfortunately, there are no nice looking switches. My solution was to fit a switch from a Td5 Discovery 2 - and print this adaptor so it can easily screw on to the steering column. This is version 2 which is a much better fit and prints in one piece. Use higher temperature filament such as PETG or PAHT - otherwise it will melt in the sun. That's how come V2 came to be! Insert a couple of M4 Nuts into the slots provided, then attach the switch with 2 x M4 x 10mm screws"

Land Rover Defender LT77 Gear knob

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Clip Front Seat Belt Retainer For Land Rover Defender

This a double fuel pipe clip for Td5 defenders, to hold fuel hoses to the chassis.

Front bumper end cap clip for Defender

Land Rover Discovery 1/2 window switch bezel. You need to print 4 pins

Land Rover Discovery 3 armrest cap.

Land Rover Discovery 2 fuel door latch.