Keep the legendin the wild.

Fixes the plastic tabs on the A Pillar that usually break when trying to remove the trim for upgrades like UHF installs

Four-piece replacement repair set for the air-conditioning louvre assembly in a 1995 Land Rover Defender 300 Tdi (1994-1998), comprising the louvre, outer frame, alignment strip, and louvre clip rail. The louvre-fit holes require drilling to 2.5 mm; the louvre requires supports and the other components print without supports. Verify the exact AC vent variant, hole size, retention, louvre movement, and cabin-heat material suitability before installation. This should also fit other pre-puma/td4 Defenders

Replacement blanking plate for unused dashboard switch openings in the Land Rover Defender TD5 (1998-2005). It fills a dashboard opening where a switch is not fitted. Verify the exact dashboard aperture, dimensions, retention, and clearance before installation. PETG is the specified printing material; support is specified for printing.

Full-size upper dashboard panel for the Land Rover Defender Td5 (1998–2005), replacing the upper dashboard top/facia component across the instrument-panel area. Verify VIN and windscreen/vent variant, drive side, demister and fastener interfaces, dimensions, clearances, and material/print strength before installation.

Drop-in ashtray-delete dash mount base for the Land Rover Defender Td5 (1998-2005). It replaces the factory top-dash ashtray with a flat, level surface for adhesive or non-slip mounting of a display, GPS, dashcam, or similar accessory, and includes a cable-routing opening. No drilling or permanent dashboard modification is required; verify the dashboard opening, device footprint, clearances, cable path, and printed-part strength before installation.

Retaining bracket for fitting an aftermarket manual shift boot to the Land Rover Freelander 1 center console. It secures a Suzuki Jimny-style boot to the Freelander console opening and provides the supporting interface beneath the boot trim.

Updated replacement clutch-switch holder for the Land Rover Freelander 1. It supports the clutch at its rest position and removes play caused by a worn original holder. The part installs from the top of the sensor opening and is secured by the existing retaining clip.

Multi-part sunroof repair kit for the Land Rover Discovery 2. It includes the outer sliding guide, guide bushing, screw spacer, and right-hand drain corner used to restore guidance, spacing, and drainage in the sunroof mechanism.

Inner center-console bracket for the Land Rover Discovery 2 switch bank. It supports four window switches, two heated-seat switches, and the rear-window lockout switch, and is intended for the fully populated seven-switch console layout.

Air intake grille. For Defenders equipped with a 300 Tdi, Td5 or Puma motor.

Ashtray-slot phone holder for the pre-Puma dashboard.

Defender wing grills, need drilling.

Simple light guards for Land Rover Defender, just attache them with the original screws.

Keep snow, ice, and leaves out of your heater intake with this Snow Cowl. The heater intake cover fits Left Hand Drive Defenders (this goes on the Right Hand Wing).

Land Rover Defender Internal Door Handle

Land Rover Discovery 2 window and heating switch cover. You need to print 4 pins.

This is a defender door's lock escutcheon

LandRover Discovery 2 Rear light cover The model provided is for the LEFT side, use the flip/mirror function in your slicer to flip the models for the right side. Can be printed as is, fine details are better. Print in ABS, looks good with some finishing and paint. Helps lights from falling out or getting hit.