Browse the parts catalogue

Four-piece replacement repair set for the air-conditioning louvre assembly in a 1995 Land Rover Defender 300 Tdi (1994-1998), comprising the louvre, outer frame, alignment strip, and louvre clip rail. The louvre-fit holes require drilling to 2.5 mm; the louvre requires supports and the other components print without supports. Verify the exact AC vent variant, hole size, retention, louvre movement, and cabin-heat material suitability before installation. This should also fit other pre-puma/td4 Defenders

Replacement blanking plate for unused dashboard switch openings in the Land Rover Defender TD5 (1998-2005). It fills a dashboard opening where a switch is not fitted. Verify the exact dashboard aperture, dimensions, retention, and clearance before installation. PETG is the specified printing material; support is specified for printing.

Full-size upper dashboard panel for the Land Rover Defender Td5 (1998–2005), replacing the upper dashboard top/facia component across the instrument-panel area. Verify VIN and windscreen/vent variant, drive side, demister and fastener interfaces, dimensions, clearances, and material/print strength before installation.

Updated replacement clutch-switch holder for the Land Rover Freelander 1. It supports the clutch at its rest position and removes play caused by a worn original holder. The part installs from the top of the sensor opening and is secured by the existing retaining clip.

Inner center-console bracket for the Land Rover Discovery 2 switch bank. It supports four window switches, two heated-seat switches, and the rear-window lockout switch, and is intended for the fully populated seven-switch console layout.