Land Rover Discovery 1 3D-printable parts

Land Rover Discovery 2 window and heating switch cover. You need to print 4 pins.

Three alternative inserts for an ashtray or coin-tray opening: a blank panel, a three-switch panel, and a dual socket panel.

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Replacement socket clip for the headlight adjuster. Two screws secure the clip to the lamp and the socket snaps onto the adjuster ball

Land Rover Discovery 1/2 window switch bezel. You need to print 4 pins

Repair set for later window-regulator motor assemblies, including gear-coupler and roller options. Some versions require drilling and tapping the original steel hub or roller shaft

Replacement blanking button for an unused dashboard switch position. Two model variants are included

Multi-part dashboard tray replacement with interchangeable faces for USB, a brake-controller dial, or three Carling-style switches. Glue the selected face to the tray after test-fitting.

52mm hub nut socket for a wide range of Land Rover models. Most wheel bearings only need gentle torque - a few later models use the same nut but with huge torque and this likely won't work for those. 1/2" socket plus a 27mm (wheel nut) sized hex on the back. Designed to be printed without supports. Print in something robust.

Workshop fitting tool for seating the rear hub seal squarely.

Dashboard surround for fitting a protruding double-DIN navigation head unit without cutting the original dash trim. PETG is recommended because PLA can deform in a hot cabin.

Replacement for the rear ashtray that accepts a standard cigarette-lighter or USB power socket. Use a cabin-temperature-resistant material and verify socket dimensions.

Replacement cover for the window-switch panel on three-door vehicles. Confirm switch layout and panel dimensions before printing.

Replacement push-fit stud used between the passenger and rear door cards and the plastic receivers in the door structure. Multiple clips are used per panel

Replacement pair for cracked rear loadspace-cover brackets.

Angled roof-console pod for two 52 mm gauges. Installation requires trimming part of the original mating flange and securing the pod with small countersunk screws.

Three-part replacement sun-visor retainer for either side. Print the body flat, the clip prongs upward, and the cap with its tube upward, then glue the clip into the body before installation.

Two-part centre-console cup holder with an enlarged approximately 75 mm internal diameter and no phone pocket. Designed from a related holder and explicitly stated to fit this generation.

Bolt-on repair pieces for parcel-shelf eyelets that have torn through. Requires trimming the shelf and two M3 x 7 mm fasteners

Replacement left-hand cover for the power-seat switches on a 1996 vehicle. The ribbed design differs slightly from the original

Reinforced replacement bracket for a broken rear parcel shelf. Compare side and mounting geometry with the original before printing.