Browse the parts catalogue

Defender door card clip

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

This is a defender's door card clip mount

Clip Front Seat Belt Retainer For Land Rover Defender

Defender Bonnet Stay Clip, requires a 3mm Allen screw.

Front bumper end cap clip for Defender

Clip to hold brake pipes to chassis for Defender TD5. It fits into existing 7mmØ holes in chassis and holds a 5mmØ brake pipe secured by a 4.7mm*1.3mm nylon cable tie. It's designed to be forced into the chassis with a hammer and strongly hold the brake pipe even without beeing secured by the cable tie, but be aware that brake pipes are quite sensible parts of a vehicle and may result to your death if not secured appropriately. Use this part at your own risk and check conditions of the brake pipe clip regularly.

Repair clip for a broken rear-seat latch, supplied with a trim-removal tool. Reuses the original spring

Trim Clip for Fuse Box Cover on Defender from 2007 Onwards

Replacement socket clip for the headlight adjuster. Two screws secure the clip to the lamp and the socket snaps onto the adjuster ball

Replacement push clip for the front cowl and wiper-panel cover on 2002–2009 vehicles. Use a flexible, weather-resistant material and compare dimensions with an original clip before fitting.

This a double fuel pipe clip for Td5 defenders, to hold fuel hoses to the chassis.

Bolt-on lower clip and rotating sleeve for repairing the glovebox damper. Install with an M3 × 16 mm fastener, nut, and locking washer, and orient the clip for strength as shown by the source.

Two-piece overlay repair for a broken glovebox-damper attachment. The body clips over the damaged damper and a half-ring lock provides additional retention.

Replacement quarter-turn retaining clip for the rear tow-hitch cover.

Replacement threaded carpet retainer.

Replacement retaining clip for the rear tow-hitch cover and related exterior panels.

Three-part replacement sun-visor retainer for either side. Print the body flat, the clip prongs upward, and the cap with its tube upward, then glue the clip into the body before installation.

Replacement push-fit stud used between the passenger and rear door cards and the plastic receivers in the door structure. Multiple clips are used per panel

Replacement retaining clip for the plastic wind deflector mounted beneath each front wiper arm on 2002–2012 vehicles. Use a weather- and UV-resistant material.

Adapter that allows compatible standard 22-inch wiper blades to fit the L322 front wiper arm without additional hardware. The source recommends ABS, three perimeter walls, 40% infill, and supports.

Bolt-on adapter for the side-arm front wiper fitting used on 2003–2012 vehicles, converting it to accept a conventional cross-bar blade attachment. Includes editable OpenSCAD source.

Replacement captive clip for securing a number-plate screw when the original body clip is missing. The source recommends cutting the screw thread before installing the clip and using a tougher material than PLA.

Top half of the twist-lock clip for P38 rubber floor mats. The upper retainer has no confirmed standalone Land Rover part number. Use ABS rather than brittle PLA. Converted the original ASCII STL to binary without changing its geometry for upload compatibility.