Browse the parts catalogue
Every part on this page has been printed at least once on a real truck. Search by part name, OEM cross-reference, or pick a vehicle generation to narrow it down.
Switch-Panel Mount No Holes Required
It fits in front of the ignition-switch, designed for the eezee power switch panel so it has a mounting surface of 68x115 mm and mirrored version for RHD vehicles
Lower Dashboard Air Vent
Replacement lower-dashboard air vent in the later flat style.
Glovebox-Damper Bottom Clip
Bolt-on lower clip and rotating sleeve for repairing the glovebox damper. Install with an M3 × 16 mm fastener, nut, and locking washer, and orient the clip for strength as shown by the source.
Rivet - Plastic Wheel flare
REQ-AFU1075
Multi-purpose plastic snap fastener used to attache the wheel flares
Window Winder Handle Escutcheon
REQ-BTR6620PMA
Chrome or black escutcheon plate that sits behind the manual window winder handle against the door card.
A-Pillar Rain Gutter Finisher (Right)
REQ-DCB500060PMA
Plastic trim piece that covers the A-pillar rain gutter on the right side. One of the most commonly broken Discovery 2 parts. UV degrades the plastic and rivets fail.
A-Pillar Rain Gutter Finisher (Left)
REQ-DCB500070PMA
Plastic trim piece that covers the A-pillar rain gutter on the left side. Same notorious failure as the right side.
Front Bumper End Cap
REQ-LR013413X
Plastic end cap that covers the end of the front bumper. Prevents water and dirt from getting inside the bumper.
Headlight Surround Bezel Right Side
REQ-LR051109
Right side, plastic, headlamp finisher panel with horn vents
End of the racks · 12 entries