Browse the parts catalogue

This is the rear left and right window liner. This requires a larger printer but you can cut it in the slicer and join it afterwards

Drop-in ashtray-delete dash mount base for the Land Rover Defender Td5 (1998-2005). It replaces the factory top-dash ashtray with a flat, level surface for adhesive or non-slip mounting of a display, GPS, dashcam, or similar accessory, and includes a cable-routing opening. No drilling or permanent dashboard modification is required; verify the dashboard opening, device footprint, clearances, cable path, and printed-part strength before installation.

Custom panel for a Range Rover P38 stock radio slot, holding auxiliary switches, the ride-height switch, and the interior-air-temperature sensor after relocating the original radio. This is a community accessory with no Land Rover Genuine part number. The source recommends printing the front panel flat on the bed at about 20% infill without supports.

Custom replacement for the front ashtray section of a 1999 Range Rover P38 4.0 automatic. Includes a standard cigarette-lighter socket opening, space for additional switches, a 2 mm smaller version for vinyl covering, and separate mounting brackets for printers with smaller beds. The related 1999 front centre-console ashtray assembly is Land Rover FKH100350

Three-part loadspace-light conversion comprising an installation template, switch panel, and blanking plate. Wiring polarity and switching differ between early and later vehicles, so verify the circuit before modification.

Retaining bracket for fitting an aftermarket manual shift boot to the Land Rover Freelander 1 center console. It secures a Suzuki Jimny-style boot to the Freelander console opening and provides the supporting interface beneath the boot trim.

Blanking panel for the rear climate-control aperture in the Land Rover Defender L663 cubby box. It closes the unused opening when the cubby box is installed in a vehicle or configuration without rear heating controls.

It fits in front of the ignition-switch, designed for the eezee power switch panel so it has a mounting surface of 68x115 mm and mirrored version for RHD vehicles

Three-piece adaptor set for fitting a 1995 Ford F-150 throttle-position sensor to a 1994 3.9-litre V8 throttle body. The creator specifies PETG for engine-bay heat resistance.

Adapter that allows compatible standard 22-inch wiper blades to fit the L322 front wiper arm without additional hardware. The source recommends ABS, three perimeter walls, 40% infill, and supports.