Land Rover Discovery 3D-printable parts

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Land Rover Discovery 2 window and heating switch cover. You need to print 4 pins.

Land Rover Discovery 2 bonnet (Hood) prop grommet

Three alternative inserts for an ashtray or coin-tray opening: a blank panel, a three-switch panel, and a dual socket panel.

Workshop fitting tool for seating the rear hub seal squarely.

Dashboard bracket for a 9.3-inch portable CarPlay display. The upper edge tucks beneath the dashboard trim while taped feet support the screen

Land Rover Discovery 1/2 window switch bezel. You need to print 4 pins

LandRover Discovery 2 Rear light cover The model provided is for the LEFT side, use the flip/mirror function in your slicer to flip the models for the right side. Can be printed as is, fine details are better. Print in ABS, looks good with some finishing and paint. Helps lights from falling out or getting hit.

52mm hub nut socket for a wide range of Land Rover models. Most wheel bearings only need gentle torque - a few later models use the same nut but with huge torque and this likely won't work for those. 1/2" socket plus a 27mm (wheel nut) sized hex on the back. Designed to be printed without supports. Print in something robust.

Land Rover Discovery 2 horn button cover.

Replacement air intake for a Webasto Thermo Top V fuel-burning heater when the original retaining legs have broken. Print with the legs downward and supports from the build plate.

Land Rover Discovery 3 armrest cap.

Repair set for later window-regulator motor assemblies, including gear-coupler and roller options. Some versions require drilling and tapping the original steel hub or roller shaft

Tool-free half-turn thumbwheel fastener for the rear towing-point cover. Print at 100% infill for strength.

Repair clip for a broken rear-seat latch, supplied with a trim-removal tool. Reuses the original spring

Land Rover Discovery 2 fuel door latch.

Two-part centre-console organiser comprising a main tray and removable divider. Use a cabin-temperature-resistant material because PLA may soften in summer heat.

Replacement socket clip for the headlight adjuster. Two screws secure the clip to the lamp and the socket snaps onto the adjuster ball

Dashboard phone mount for fitting a Quad Lock interface in the Discovery 3/LR3 cabin. Confirm the mating interface and dashboard fit before final installation.

Replacement plunger for a broken fuel-filler-door actuator.

Push-fit cap for covering an unused roof-rack mounting hole.

Replacement receiver that grips the quarter-turn plastic screw securing the rear tow-bar cover.

Wheel-centre reference tool that holds a tape measure at the true hub centre during suspension-height calibration.

Replacement pair for cracked rear loadspace-cover brackets.