Land Rover Discovery 4 3D-printable parts

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Dashboard bracket for a 9.3-inch portable CarPlay display. The upper edge tucks beneath the dashboard trim while taped feet support the screen

Two-piece radio surround and mounting bracket designed for a flush Pioneer double-DIN installation

Holder that keeps a second-row seat-belt buckle upright so children can buckle themselves more easily. Designed around the Discovery mid-row seat geometry.

Tool-free half-turn thumbwheel fastener for the rear towing-point cover. Print at 100% infill for strength.

Repair clip for a broken rear-seat latch, supplied with a trim-removal tool. Reuses the original spring

Shield that prevents the inner rear parking sensors from detecting a raised aftermarket tow hitch. Print two in ASA or another UV- and heat-resistant material.

Replacement receiver that grips the quarter-turn plastic screw securing the rear tow-bar cover.

Two-part eyelet mount that clamps around a factory roof rail using common M8 hardware. The source recommends PETG, 20% infill, doubled infill lines, and three walls. Use only for light-duty restraint and never as a rated recovery or lifting point.

This 3D-printed seat lever cover is designed as a replacement cover for the seat-folding lever mechanism used for the 6th and 7th passenger seats. It provides a neat, durable solution when the original plastic cover is damaged, missing or worn.

Replacement air intake for a Webasto Thermo Top V fuel-burning heater when the original retaining legs have broken. Print with the legs downward and supports from the build plate.

Replacement plunger for a broken fuel-filler-door actuator.

Push-fit cap for covering an unused roof-rack mounting hole.

Replacement nozzle for the cabin air duct, supplied in screw-in and long-thread versions for differently damaged mounting holes. The source recommends printing upright in PETG.