Land Rover Freelander 1 3D-printable parts

Replacement end cap for the passenger roof grab handle, measured from a 2000 four-door vehicle.

Four-part clamp mount for attaching a Salora CDC100-style dashcam to the interior mirror. Short and tall ball-arm options are included, together with the mirror clamp and retaining nut.

Replacement threaded carpet retainer.

Replacement driven gear for a window-regulator motor mechanism.

No-drill rear-camera holder that replaces one number-plate-light position. Confirm camera dimensions, cable routing, and local lighting requirements before installation.

Replacement bushing for the manual gear linkage above the gearbox, intended to reduce excess movement during gear selection. Use a durable, wear-resistant material and verify the linkage joint before fitting.

Retaining bracket for fitting an aftermarket manual shift boot to the Land Rover Freelander 1 center console. It secures a Suzuki Jimny-style boot to the Freelander console opening and provides the supporting interface beneath the boot trim.

Updated replacement clutch-switch holder for the Land Rover Freelander 1. It supports the clutch at its rest position and removes play caused by a worn original holder. The part installs from the top of the sensor opening and is secured by the existing retaining clip.

Two-piece fixing for securing the loadspace carpet.

Press sleeve for fitting a support bearing onto the viscous-coupling unit while loading the bearing inner race.

Replacement cover for a locking wheel nut.