Land Rover Freelander 3D-printable parts

Four-part clamp mount for attaching a Salora CDC100-style dashcam to the interior mirror. Short and tall ball-arm options are included, together with the mirror clamp and retaining nut.

Replacement end cap for the passenger roof grab handle, measured from a 2000 four-door vehicle.

Three-part loadspace-light conversion comprising an installation template, switch panel, and blanking plate. Wiring polarity and switching differ between early and later vehicles, so verify the circuit before modification.

Deep dashboard-console mount for integrating a seven-inch tablet. Installation requires electrical adaptation and modification of the tablet controls

Multi-part workshop tool for removing and installing the cabin blower motor. It requires M5 threaded rod, nuts, bolts, and bonded inserts

Bolt-on lower clip and rotating sleeve for repairing the glovebox damper. Install with an M3 × 16 mm fastener, nut, and locking washer, and orient the clip for strength as shown by the source.

Replacement internal gear set for a failed tailgate-lock actuator. Three printable variants are included

Support ring fitted beneath the fuel-cap thread seal to improve compression and help prevent evaporative-system leaks.

Replacement cap for the windscreen-washer reservoir.

Two-piece overlay repair for a broken glovebox-damper attachment. The body clips over the damaged damper and a half-ring lock provides additional retention.

Two-piece coin organiser for the centre-console area, comprising a main holder and lid.

Two-piece fixing for securing the loadspace carpet.

Press sleeve for fitting a support bearing onto the viscous-coupling unit while loading the bearing inner race.

No-drill rear-camera holder that replaces one number-plate-light position. Confirm camera dimensions, cable routing, and local lighting requirements before installation.

Replacement bushing for the manual gear linkage above the gearbox, intended to reduce excess movement during gear selection. Use a durable, wear-resistant material and verify the linkage joint before fitting.

Replacement threaded carpet retainer.

Replacement driven gear for a window-regulator motor mechanism.

Replacement cover for a locking wheel nut.