Land Rover Freelander 2 3D-printable parts

Three-part loadspace-light conversion comprising an installation template, switch panel, and blanking plate. Wiring polarity and switching differ between early and later vehicles, so verify the circuit before modification.

Deep dashboard-console mount for integrating a seven-inch tablet. Installation requires electrical adaptation and modification of the tablet controls

Multi-part workshop tool for removing and installing the cabin blower motor. It requires M5 threaded rod, nuts, bolts, and bonded inserts

Bolt-on lower clip and rotating sleeve for repairing the glovebox damper. Install with an M3 × 16 mm fastener, nut, and locking washer, and orient the clip for strength as shown by the source.

Replacement internal gear set for a failed tailgate-lock actuator. Three printable variants are included

Support ring fitted beneath the fuel-cap thread seal to improve compression and help prevent evaporative-system leaks.

Replacement cap for the windscreen-washer reservoir.

Two-piece overlay repair for a broken glovebox-damper attachment. The body clips over the damaged damper and a half-ring lock provides additional retention.

Two-piece coin organiser for the centre-console area, comprising a main holder and lid.