Land Rover Series 2A 3D-printable parts

A cup holder that clips to the metal dash of a Series 1-2a.

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Three-part replacement socket assembly for an indicator or position lamp using a separate single-contact bulb holder. Verify the 33 mm housing fit, wiring, insulation, and weather sealing.

Its an alternative to the front grille screw plastic mounts.

Six-piece replacement kit redrawn from surviving original plastic and bakelite wiper-motor components. The positive-terminal insulator uses a simplified M3 through-bolt connection.

Originally built to mount a Bolt&Trim Leather speaker holder for the Marshall speaker. This allows for a temporary/movable mount based originally on a cup holder. Could be easily modified for other speaker styles.

Loose- and tight-fit holders for fitting a 5 mm 12-volt LED and panel-mount bezel into a 16 mm Jaeger or Smiths gauge opening. The creator notes that the tight version may break during removal and suggests optional hot glue after installing the LED.

Door-hinge packing shims in three thicknesses. They also separate dissimilar metals to help reduce electrolytic corrosion

Replacement UP–DOWN heater airflow control button. Compare the lever slot and lettering orientation with the original before printing and fitting.

52mm hub nut socket for a wide range of Land Rover models. Most wheel bearings only need gentle torque - a few later models use the same nut but with huge torque and this likely won't work for those. 1/2" socket plus a 27mm (wheel nut) sized hex on the back. Designed to be printed without supports. Print in something robust.

Eleven thickness variants of the isolating shim fitted between the chassis brackets and rear tub to separate dissimilar metals.

Workshop mandrel for centring the clutch plate during assembly. Confirm the spigot and spline diameters against the gearbox input shaft and clutch before use.

Replacement threaded button for the handbrake lever. The source recommends finishing the undersized bore with an M5 tap for a secure fit.

Replacement COLD–WARM heater control button. Compare the lever slot and lettering orientation with the original before printing and fitting.

If you mount the MRC7354 "Soft Top Front Seat Belt Bar For Land Rover Defender / Series" the tube do not fit very well the the capping. This part gives it a nice an stable connection. Needs tu be drilled trough after mounting fpr a tight fit. Drill 8 mm oder 5/16 "

Replacement bush used with a standard 5/16-inch bolt and locking nut to align the brake shoes. Tap the printed bore to suit the bolt thread and follow the source adjustment method.