Land Rover Defender Puma 3D-printable parts

Air intake grille. For Defenders equipped with a 300 Tdi, Td5 or Puma motor.

Simple light guards for Land Rover Defender, just attache them with the original screws.

Defender wing grills, need drilling.

Keep snow, ice, and leaves out of your heater intake with this Snow Cowl. The heater intake cover fits Left Hand Drive Defenders (this goes on the Right Hand Wing).

Land Rover Defender Internal Door Handle

This is a defender door's lock escutcheon

Defender door card clip

Defender Bonnet Stay Clip, requires a 3mm Allen screw.

This is a defender door's lock button housing

This is the defender door's sill lock button

Cubby-box extension with two cup recesses and a central storage pocket.

Plastic bushing fro Land Rover Defender bonnet

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

This is a defender's door card clip mount

Its an alternative to the front grille screw plastic mounts.

Land Rover Defender Door Panel Dowel

This is a defender's seat lever knob

Dashboard mounting bracket for a Garmin navigation unit in the Puma interior.

Push-fit 27 mm wheel-nut cover.

Clip Front Seat Belt Retainer For Land Rover Defender

Front bumper end cap clip for Defender

Workshop wrench for removing and tightening the fuel-sender retaining ring.

Land Rover defender mirror hinge bottom cap

Eleven thickness variants of the isolating shim fitted between the chassis brackets and rear tub to separate dissimilar metals.