Defender

Air intake grille. For Defenders equipped with a 300 Tdi, Td5 or Puma motor.

Ashtray-slot phone holder for the pre-Puma dashboard.

Defender wing grills, need drilling.

Simple light guards for Land Rover Defender, just attache them with the original screws.

Keep snow, ice, and leaves out of your heater intake with this Snow Cowl. The heater intake cover fits Left Hand Drive Defenders (this goes on the Right Hand Wing).

Land Rover Defender Internal Door Handle

This is a defender door's lock escutcheon

Defender door card clip

Defender Bonnet Stay Clip, requires a 3mm Allen screw.

Land Rover Defender LT77 Gear knob

Cubby-box extension with two cup recesses and a central storage pocket.

This is a defender door's lock button housing

This is the defender door's sill lock button

Plastic bushing fro Land Rover Defender bonnet

This is a defender's door card clip mount

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

Its an alternative to the front grille screw plastic mounts.

Land Rover Defender Door Panel Dowel

This is a defender's seat lever knob

This is the rear left and right window liner. This requires a larger printer but you can cut it in the slicer and join it afterwards

Clip-in dashboard-vent deflector that directs part of the demister airflow towards the side window. The creator positions it over the vent funnel, about 150 mm from the outer end.

Dashboard mounting bracket for a Garmin navigation unit in the Puma interior.

Push-fit 27 mm wheel-nut cover.

Drop-in ashtray-delete dash mount base for the Land Rover Defender Td5 (1998-2005). It replaces the factory top-dash ashtray with a flat, level surface for adhesive or non-slip mounting of a display, GPS, dashcam, or similar accessory, and includes a cable-routing opening. No drilling or permanent dashboard modification is required; verify the dashboard opening, device footprint, clearances, cable path, and printed-part strength before installation.