Land Rover Defender 300 Tdi 3D-printable parts

Air intake grille. For Defenders equipped with a 300 Tdi, Td5 or Puma motor.

Ashtray-slot phone holder for the pre-Puma dashboard.

Simple light guards for Land Rover Defender, just attache them with the original screws.

Defender wing grills, need drilling.

Keep snow, ice, and leaves out of your heater intake with this Snow Cowl. The heater intake cover fits Left Hand Drive Defenders (this goes on the Right Hand Wing).

Land Rover Defender Internal Door Handle

This is a defender door's lock escutcheon

Defender door card clip

Land Rover Defender LT77 Gear knob

This is a defender door's lock button housing

This is the defender door's sill lock button

Cubby-box extension with two cup recesses and a central storage pocket.

Plastic bushing fro Land Rover Defender bonnet

Holds the seatbelt latch so it does not slide down past the shoulder. Universal to any seatbelt of standard width. (3MF file)

This is a defender's door card clip mount

Its an alternative to the front grille screw plastic mounts.

Land Rover Defender Door Panel Dowel

This is a defender's seat lever knob

Push-fit 27 mm wheel-nut cover.

Clip Front Seat Belt Retainer For Land Rover Defender

Multi-part dashboard housing, frame, gauge mount, button, adaptor, and support bracket for the BinOwl onboard-computer installation.

Two fit variants of a blanking plate for the 1998 dashboard ashtray opening.

Clip-in dashboard-vent deflector that directs part of the demister airflow towards the side window. The creator positions it over the vent funnel, about 150 mm from the outer end.

Workshop wrench for removing and tightening the fuel-sender retaining ring.